Progression Week 11

FYP 1 PRESENTATION

My  assessor for my presentation are Dr Mohd Noor and Madam Sabrina. I had presented about my idea that is the Development of Electric Wheelchair controlled by EMG circuit complete with its methodology, problem statements and many more.

                                              

During the presentation, Madam Sabrina more questions about how the process is carried out to get the best EMG signal to move the wheelchair. For her, in her experience for obtain EEG signal itself are very difficult because the voltage produced is very low. Dr Mohd Noor more to support Madam Sabrina question because for him, the EMG signal itself plays an important role in the production of this wheelchair.

At the end of the presentation, they both give advice and views on project that I will run. They asked me to consult more with my supervisor on this project.

Progression Week 10

Preparation for my presentation slide

For this week, I started doing my presentation slide. There are eight topics that need to attach in the slide show, where are:

• Introduction - the background of the project title
• Problem Statement - problems that need to be solve
• Aim and Objectives - Objectives of the project must support and achieve the aim
• Scope and Limitation - explain general and method to be used
• Literature Review
• Methodology - consists of Block Diagram and Flow Chart 
• Expected Budget
• Expected Result

The presentation slide must not be less than 8 slides and should not exceed than 15 slides. The total slides must not include front page.

Progression Week 9

WORK PLAN

Table below shows the Gantt chart which is the overall planning for the preparation of Meter Bill for Distribution Panel. The time frame allocated for this research study is 4 months. It is started in September 2014 and will be completed in December 2014. It is divided into 14 weeks. The Gantt chart for this project is shown in Table.

The chart is divided into 13 tasks to achieve the project objectives. Each task will follow the sequence form week to week. Based on the chart, the most challenging task is making a research about EMG signals and components to be used in this project. It needs more time to find and survey suitable components and material that going to be used for the project.

Besides, the designing of flow chart of the product and the block diagram are also a challenging task during conducting this research. It needs more understanding on how the system work as the block diagram is easier for drafting the exact situation of how the system works.

Progression Week 8

The Illustration for the EMG Electric Wheelchair

Figure shows the design illustration of the product of EMG Electric Wheelchair.